User manual

chapter 12 effects 153
Change downfade only
Follow these steps to change only the effect’s downfade time.
Change dwell only
Follow these steps to change only the effect’s dwell time.
Reset Hold dwell time
If the dwell time is set to Hold, an effect submaster will continue to run
until you press the bump button. An effect cue will continue to run until
you press either [Go] or [Hold] [Hold]. To reset the dwell time to Hold
follow these steps:
Keystrokes:
Action:
1. Press [Blind] [Cue] [2].
Selects cue 2 in the Blind display
2. Press [Time] [Time] [Time].
Prompt reads:
Enter effect downfade time
3. Enter the downfade time.
Prompt reads:
Enter effect downfade time
4. Press [Enter].
Prompt reads:
Select step numbers
Keystrokes:
Action:
1. Press [Blind] [Cue] [2].
Selects cue 2 in the Blind display
2. Press [Time] [Time].
Prompt reads:
Enter effect dwell time
3. Enter the dwell time.
Prompt reads:
Enter effect dwell time
4. Press [Enter] [Enter].
Prompt reads:
Select step numbers
Keystrokes:
Action:
1. Press [Blind] [Cue] [2].
Selects cue 2 in the Blind display
2. Press [Time] [Time].
Prompt reads:
Enter effect dwell time
3. Press [Clear].
Prompt reads:
Enter effect dwell time
4. Press [Enter] [Enter].
Dwell time set to Hold
Prompt reads:
Select step numbers