User manual

134 Insight 2x user manual
Adding a rate to a submaster
Rate allows you to record submasters that play back faster or slower than
their recorded fade times. This can be especially helpful when you are
trying to calculate complex timing information for effects loaded to a sub-
master.
Note: If you adjust the rate on a submaster containing an effect, the rate
adjustments affect individual step timing, but do not change the overall
effect timing.
Rate is expressed as a percentage. A submaster with a rate of 100 plays
back at its recorded fade time. A rate of 300 plays the submaster back
three times faster than its recorded fade time. A rate of 50 causes it to
play back half as fast as its recorded fade time. You may assign a rate of
up to 2,000 percent.
To add a rate to submaster 7, follow these steps:
Specifying a submaster’s page
You may specify the page to which you record submasters . For example,
if page 1 is loaded, you can record a submaster to page 2 . To do so, follow
these steps:
Action: Keystrokes:
1. Press [Blind]. Selects Blind display mode
2. Press [Sub] [7]. Prompt reads:
Select submaster number
To select submaster type, press
TYPE
3. Press [S3], Rate. Prompt reads:
Use keypad to select submaster rate
(0 to 2000, 100 = Normal)
4. Press [1][5][0]. Corner reads: Rate 150
5. Press [Enter]. Rate of 150 percent is recorded into
submaster 7
Keystrokes: Action:
1. Create a look in Stage.
2. Press [Record] [Sub].
Prompt reads:
To record submaster, select
number and press ENTER
To cancel, press CLEAR
3. Press [Page] [2].
Prompt reads:
Select page on which to record
submaster, then press submaster
bump button
4. Press submaster 6’s bump
button.
Current levels are recorded into
submaster 6 on submaster page 2