User manual

132 Insight 2x user manual
Adding fade and dwell times
You can add fade and dwell times to a submaster from Stage or Blind
mode. To add fade times to a submaster, follow these steps in either
mode:
Note: Once a timed submaster is running, press the bump button to
change the direction of the fade. For example, if the upfade is half fin-
ished, pressing the bump button starts the downfade from 50 percent. If
a downfade is running, pressing the bump button begins an upfade again
from the current level.
Keystrokes: Action:
1. Press [Sub].
Prompt reads:
Select submaster number
To select submaster type, press
TYPE
2. Press [5].
Selects submaster 5
Corner reads:
Sub 5
3. Press [Time] .
Prompt reads:
Enter upfade time
4. Use keypad to enter
upfade time and press
[Time] .
Prompt reads:
Enter dwell time
(Press CLEAR for hold, press CLEAR
CLEAR for manual operation)
5. Use keypad to enter dwell
time and press [Time] .
(See next page for infor-
mation about using a Hold
dwell.)
Prompt reads:
Enter downfade time
6. Use keypad to enter down-
fade time and press
[Enter].
New fade times are recorded into
submaster 5