User manual

130 Insight 2x user manual
Bump button mode
Submaster bump buttons may be set in Channel or Submaster modes. In
either mode, you have the option of putting them in Solo mode. The fol-
lowing sections describe each mode.
Submaster mode
Press the [Sub Mode] key to switch the submaster bump buttons into
Submaster mode. The submasters recorded in the console’s submaster
memories are loaded into the submaster sliders. Each submaster slider
and bump button now controls its assigned submaster.
Channel mode
Press the [Sub Mode] key again to switch the submaster bump buttons
into Channel mode. In channel mode, each submaster slider and bump
button controls the correspondingly numbered channel, i.e., slider 1 con-
trols channel 1, slider 2 controls channel 2 and so forth.
Solo mode
Press [Solo Bump] to put the submaster bump buttons into Solo mode.
The LED inset into the key lights to indicate that Solo mode is active. in
Solo mode, pressing any submaster bump button brings its channels to
their recorded level (or brings its channel to Full if in Channel mode) and
takes all other channels to zero.