User manual

126 Insight 2x user manual
Submaster pages
Insight 2x provides ten pages of submasters. A page is a block of console
memory that contains one set of 108 recorded submasters, correspond-
ing to the 108 submaster sliders. The ten pages of memory increases the
number of possible submasters to 1,080.
Insight 2x displays the message Sub page 1 (2, 3...) in the upper right
corner of the Playback display to indicate the current submaster page . To
switch from one page to the other, press [Page], enter the desired page
number, and press [Enter].
When you switch submaster pages, any submasters on stage remain on
stage until you move their sliders to the home position. Until the new sub-
master loads, submaster LEDs flash slowly, indicating that the submaster
on stage is from the previously loaded page. If flashing red, the new sub-
master is inhibitive; if green, the new submaster is pile-on. When you
move the slider to its home position the new submaster is loaded and the
LED stops flashing. This prevents the stage from going black or changing
levels when you switch pages. (Fast flashes designate a submaster with
a dwell time of Hold. See
Submaster LEDs on page 128 for more informa-
tion about LEDs.)
Note: When you read a new show into the console from a disk, the con-
sole loads the same page number that was loaded from the previous
show. Any submasters on stage when you read a new show into the con-
sole remain on stage until you move their sliders to the home position.
Until the new submaster loads, submaster LEDs flash, indicating that the
submaster on stage is from the previously loaded show. If flashing red,
the new submaster is inhibitive; if green, the new submaster is pile-on.
When you move the slider to its home position the new submaster is
loaded and the LED stops flashing.