User manual

118 Insight 2x user manual
Using cues or submasters as groups
If you wish, you can treat the channels recorded in a cue or a submaster
as if they were a group, bringing them up on stage or including them in
other level setting operations.
For example, to bring up a cue on stage as a group, follow these steps:
To use a submaster as a group, follow the same procedure, but press
[Sub] instead of [Cue] in step 3.
Note: You may not group the channels in a cue part, only in a whole cue.
Note: You may not group the channels in an effect cue or effect
submaster.
Keystrokes: Actions:
1. Press [Stage]. Selects Stage display mode
2. Press [Group]. Tells Insight 2x to treat the next entry
as a group
Prompt reads:
Group mode – Select group number
to use as group
3. Press [Cue] and enter the
number of the cue you
want to bring up.
Prompt reads:
Group mode – Select cue number to
use as group
4. Press [At] and enter the
level at which you wish to
bring the cue up. (Or press
[Full].)
The cue’s channels are brought up on
stage at the specified level
Prompt reads:
Group mode – Press AT or use wheel
to alter levels, or select channel
numbers to edit