User manual

102 Insight 2x user manual
Selecting and playing a cue
Selecting a cue moves it to the top of the Cue List. It will not run until you
press [Go]. Follow these steps to select a cue and play it on the fader of
your choice.
Go
Each fader has its own [Go] key. Press [Go] to play back the cue selected
on the Cue List.
If you have pressed [Hold] to interrupt the playback of a cue, press [Go] to
resume the fade.
If you press [Go] before a cue finishes playing, the previous cue stops, and
the new cue begins from the levels at which the previous cue was inter-
rupted.
Hold
Each fader has its own [Hold] key. If a cue is running, press [Hold] to pause
playback of the cue. Press [Hold] a second time to cancel playback of the
cue in the fader, leaving it in the fader where it stopped, or press [Go] to
resume the fade.
Keystrokes:
Action:
1. Press [Stage].
Selects Stage display mode
2. Press [Cue].
Prompt reads:
Select cue number
To select cue type, press TYPE
3. Press [1][.][5].
Selects cue 1.5 to play
4. Press [Enter].
Cue List moves cue 1.5 to the top of
the list
5. Press [Go] on fader A/B.
Cue 1.5 runs on fader A/B; Cue 2
moves to the top of the Cue List
6. Press [Go] on fader C/D.
Cue 2 starts to run on fader C/D