User manual

96 Insight 2x user manual
Modifying fade and wait times
If you do not assign fade and wait times to a part, Insight 2x automatically
assigns it the default times. See Setting default fade times on page 17. No
wait time will be recorded. Follow these steps to assign fade and wait
times to parts in a multipart cue:
Keystrokes:
Action:
1. Press [Blind].
Selects Blind display mode
2. Enter the cue number.
Prompt reads:
Select cue number
To select cue type, press TYPE
3. Press [Part]; then press
[+] or [-] until the part you
want to edit is displayed.
Prompt reads:
Select part number
4. Press [Time].
Prompt reads:
Enter upfade time
5. Enter an upfade time
between .1 second and
99:59 minutes and press
[Enter].
Prompt reads:
Enter downfade time
6. If you want a downfade
time that is different from
the upfade, enter the
desired time and press
[Enter]. If not, just press
[Enter].
Fade times are set for the part
7. Press [Wait].
Prompt reads: Enter wait time
8. Enter wait time and press
[Enter]. Wait time is the
delay between when you
press [Go] and when the
part begins. If you do not
enter a wait time, Insight
2x assigns a wait time of
zero.
Wait time is set for the part