Specifications

80 Chapter 6 Adding moving lights to the show
Setting levels without encoders
Use the procedure below this Navigation and Feedback table to set
attribute levels without the use of encoders, such as when you are using
a console without an attached ML module
1. With a fixture in the Fixture Box, press the up/down arrows to select
a page.
2. Select an attribute with the left/right arrows.
3. Adjust the level of the selected attribute with the Y-wheel.
9
4. If there are other fixture attributes on the same page that you wish to
set, repeat steps 2 and 3 above. Continue until finished with all
attributes on that page.
5. If attributes of this fixture are on a different page, repeat steps 1
through 4 above. Continue for all pages on which the fixture’s
attributes are located.
6. To set the channel levels of another fixture, select the fixture with the
[+] or [–] keys.
7. Repeat steps 1 through 6 until finished with all fixtures.
9.
Pan and tilt are always selected together when either is selected.
Whichever of these two attributes is selected is placed on the Y-
wheel. The other is placed on the X-wheel.
Navigation and Feedback - Fixture Box display (without encoders)
±
Select fixture XX
Select page X
Select attribute X
Page highlighted white Fixture attributes
exist on page
Page highlighted yellow Selected page
Attribute gold Attribute of
selected fixture
Attribute highlighted yellow Selected attribute