Specifications
354 Appendix C Error messages
Diskette error messages
Bad Disk
Disk is unformatted or defective. Try formatting it. If that doesn’t work, try
a different disk.
Corrupted Disk
This disk is defective. Try formatting it. If that doesn’t work, try a different
disk.
Data not recorded on disk
You cannot read the System Configuration settings from showfiles
created with software Version 3.02 or earlier. You must save the show
with 3.03 or later software to include System Configuration settings.
Disk access failed because of tracking failure
This message appears on the backup console in a Full Tracking Backup
system when the network or the master console fails during a diskette
operation.
Disk controller failure
Call ETC Technical Service at 800-775-4382.
Disk full
Disk contains other files. Remove enough files to make room for show
file.
File not found
This disk does not appear to have a show stored on it. Please confirm that
you have inserted the correct disk.
No disk in drive
Show diskette must be inserted in the diskette drive before you can save
or read a show.
Unknown disk error - try again
Try the diskette again. If it fails again, call ETC Technical Service at
800/775-4382.
Write-protected disk
The write-protect tab on this diskette is open. Close the tab to unprotect
the diskette.
Other error messages
Out of memory
You have used up all system memory allotted to the function with which
you are working. Delete unnecessary parts of the show to free up
memory. If this doesn’t work, you may want to break the show into two
shows, one for each act. This message may also appear if you attempt to
run too many effects.
The Designer's Worksheet setup and regions stored in show memory
DO NOT match what is being loaded from disk. To preserve current
Worksheet setup, press ENTER. To load new Worksheet setup and
regions from disk, press CLEAR.
Press [Enter] to retain the layout option you previously selected on the
Designer’s Worksheet setup screen. Existing regions have already been
erased. Press [Clear] to replace the current Designer’s Worksheet layout
option with the new show’s layout. New regions will be loaded with the
new show.