Specifications

Insight 3 User Manual, v.3.1 353
Appendix C
Error messages
Full Tracking Backup messages
System A does not respond. System B is now operating as a stand-
alone system. System A has been disconnected from the network. To
reconnect System A to the network, you must reboot both System A
and System B.
Console A has been turned off or disconnected. Full Tracking Backup has
turned full control of your system over to console B.
System B does not respond. System A is now operating as a stand-
alone system. System B has been disconnected from the network. To
reconnect System B to the network, you must reboot both System A
and System B.
Console B has been turned off or disconnected. Full Tracking Backup has
turned full control of your system over to console A.
Unable to connect this console as part of a tracking system because of
a conflict on the network. Verify that no more than two consoles are
attached to the network, with one set as 'A', and the other set as 'B'.
Any other combination will not be valid for tracking. Be sure to turn on
both consoles within thirty seconds of each other.
Waiting for the master console to respond. Please make sure the
master console is turned on.
Both consoles must be turned on within 30 seconds of each other for Full
Tracking Backup to be enabled.
Master console does not respond. Please check connections and
cabling and make sure that network termination resistors are
installed. This system is now operating as a stand-alone system. To re-
establish tracking, turn off both consoles, then turn both back on
within thirty seconds of each other.
Waiting for the backup console to respond. Please make sure the
backup console is turned on.
Both consoles must be turned on within 30 seconds of each other for Full
Tracking Backup to be enabled.
Backup console does not respond. Please check connections and
cabling and make sure that network termination resistors are
installed. This system is now operating as a stand-alone system. To re-
establish tracking, turn off both consoles, then turn both back on
within thirty seconds of each other.
Errors have been detected in the network. Please check connections
and cabling and make sure that network termination resistors are
installed. This system is now operating as a stand-alone system. To re-
establish tracking, turn off both consoles, then turn both back on
within thirty seconds of each other.