Specifications

Insight 3 User Manual, v.3.1 341
MIDI Out/Thru jumper setting
You may set the MIDI Out connector as a MIDI Thru port. Follow these
steps to do so:
1. Locate the jumper at location J5 (J8 for Insight 2x) on the face panel
circuit board in the lid of the console. With the lid in an upright
position, the jumper should be near the lower right corner of the
circuit board.
2. The jumper at location J5 (J8 for Insight 2x) should be installed on the
pair of pins labeled 1A for MIDI Out to be active. To use the MIDI Out
connector as a MIDI Thru connector, move the jumper to the pins
labeled 2 (B for Insight 2x).
On older consoles (with keyswitch power switches), the jumper locations
are slightly different. With older consoles, proceed as follows.
1. Locate the jumper at location J7 on the face panel circuit board in the
lid of the console. With the lid in an upright position, the jumper should
be near the lower right corner of the circuit board, just below the level
wheel.
2. The jumper at location J7 should be installed on the pair of pins
labeled 1 for MIDI Out to be active. To use the MIDI Out connector
as a MIDI Thru connector, move the jumper to the pins labeled 2.
3. Close the console and test for proper operation.