Specifications
338 Appendix A Installation
Installing the Kurta IS/ONE
The Kurta IS/ONE digitizer tablet was shipped with older Designer’s
Worksheet systems.
Follow these steps to install and configure your Kurta IS/ONE Designer’s
Worksheet:
1. Insert the 9-pin serial connector of the Designer's Worksheet cable
into the console or Remote Interface connector labeled Digitizer.
2. Insert the plug end of the pointing device (pen or stylus) in the IS/ONE
connector labeled Pen/Cursor.
3. Attach the pen holder to the upper left or right hand corner of the
Worksheet by removing the protective paper from the base and
pressing the adhesive to the tablet.
4. Place one printed template sheet under the clear plastic flap on the
digitizer.
6
5. Set the voltage selection switch to match your electrical outlet. In the
US, set the voltage switch to 110.
6. Plug the power cord into the back of the Worksheet and into an
electrical outlet or a surge protecting power strip.
7. Set the three sets of DIP switches on the Worksheet as indicated
under Designer’s Worksheet DIP switch settings, page 338.
8. Turn the Worksheet power on by pressing the on/off switch. The LED
labeled Indicator (on the back panel) is lit when power is on. If the
LED blinks four times after you turn the power on, the interface cable
is not connected correctly.
9. Follow the procedure under Setup, page 337.
10. Set DIP switches as explained below.
Designer’s Worksheet DIP switch settings
The Kurta IS/ONE Designer’s Worksheet checks DIP switch settings
when the unit is turned on. Three sets of DIP switches are located on the
back panel of the digitizer. These DIP switches need to be set as shown
below for the digitizer to function properly.
7
Switches are either Up (On)
or Down (Off). You must restart the unit for new DIP switch settings to
take effect.
6.
Additional pads of Designer’s Worksheet templates are available from
your dealer or ETC.
7.
These settings are different from those used with older Insight con-
soles.
1 2 3 4 5 6 7 8
Set A Down Down Down Down Up Up Up Up
Set B Down Up Down Up Down Down Up Up
Set C Up Up Down Down Down Down Up Down