Specifications

Insight 3 User Manual, v.3.1 337
6. Turn on your console or Remote Interface. The XGT also turns on. The
red power on LED in the back left corner should blink off and then on
again. If it doesn’t, check to be sure all cables are properly connected.
7. Place one of the standard ETC template sheets under the clear plastic
flap on the digitizer.
5
8. Follow the procedure Setup, below.
Setup
Follow the procedure below to select a template, specify where the
sliders will be controlled and calibrate the template.
5.
Additional pads of Designer’s Worksheet templates are available from
your dealer or ETC.
1. Press [Setup].
Go to setup menu
2. Press [1], System Settings,
[Enter].
Go to System Settings display
3. Press [7], Designer’s Work-
sheet Setup, [Enter].
Go to Designer’s Worksheet
Setup display
4. Press 1, 2 or 3, then [Enter].
a
a. Or press [F2], [F3] or [F4] on the Worksheet template
button bar.
Enables one of the three
template setups
5. Press [S1].
Toggles slider control between
console and digitizer
6. Touch the pen to the digitizer
region labeled Calibrate.
b
b. Or press [F1] on the Worksheet template button bar.
7. Follow instructions on the
screen to finish calibration.