Specifications

336 Appendix A Installation
Installing Designer’s Worksheet
Designer’s Worksheet is a remote digitizer tablet available for use with
ETC consoles.
3
Two different models of Kurta digitizers have been used
as Designer’s Worksheets, and each has a different configuration
procedure, described below. Refer to Kurta digitizer tablet documentation
if you need additional information.
After installing the digitizer tablet using one of the two procedures that
follow, select which template to use and where the sliders will be
controlled. Then, calibrate the template. These setup operations are all
performed in the Designer’s Worksheet Display, which is shown below.
Installing the Kurta XGT
The Kurta XGT digitizer tablet shipped with Designer’s Worksheet
systems is configured by ETC for proper performance with its consoles.
4
Follow these steps to install and configure your Kurta XGT Designer’s
Worksheet:
1. Turn off your console or Remote Interface.
2. Plug the 9-pin serial connector on the interface cable into the console
or Remote Interface connector labeled Digitizer.
3. Plug the other end of the interface cable into the interface connector
on the back panel of the XGT. There is a small arrow or dimple on the
plug. It should face up.
4. Plug the transformer cable into the DC connector on the interface
cable’s serial connector (plugged into the back panel of the console or
Remote Interface).
5. Plug the transformer into an electrical outlet or a surge protecting
power strip.
3.
See Designer’s Worksheet, page 313 for operation instructions.
4.
If you obtained the digitizer from another source or suspect that the
ETC factory settings may have changed, call ETC Technical Services
at 800-775-4382 for a copy of the Kurta XGT configuration procedure.