Specifications

Insight 3 User Manual, v.3.1 159
Playback Submaster List
The Playback Submaster List display is part of the normal playback
monitor display, shown below.
2
The Submaster List lies at the right in this
display. Listed for each submaster are its label, if assigned, whether the
submaster is active or running, its type, its rate and its percentage of
completion. The status of the submaster bump buttons (Channel Mode or
Submaster Mode) is shown under the Sub Page number.
Submaster colors
The colors used in the Submaster List provide information about the
submasters.
Gray........................A gray submaster number identifies an unrecorded
submaster. Also, submaster labels and percentage of
completion are gray.
Green .....................A green submaster number identifies a pile-on sub-
master.
Red .........................A red submaster number identifies an inhibitive sub-
master.
White......................A white submaster number identifies an effect sub-
master.
Blue ........................A blue submaster number identifies a submaster
with a rate that is currently being controlled by the
rate wheel. A blue R appears at the top of the list with
the wheel’s setting.
2.
A Cue List is also shown in this display by default. Alternatively, you
can show a Time Code List in place of the Cue List. Toggle between
these two displays by pressing [Setup] [6] [Enter] [7] [Enter], select 1
or 0, and press [Enter] again.