Specifications

Insight 3 User Manual, v.3.1 157
Changing type
You can change a submaster’s type by using the [Type] key. When you
change a submaster type, levels recorded in the submaster are retained.
This means that you can change a submaster from pile-on to inhibitive and
back without losing any level or timing information. If you change the type
to effect, channel and level information is erased.
To change a submaster’s type, follow these steps:
Type changes do not take effect while the submaster is active. An active
submaster’s bump button LED blinks after you change its type. To
deactivate it, move its slider to zero if the green LED blinks, or to 10 if the
red LED blinks.
1
Keystrokes: Action:
1. Press [Blind]. Selects Blind display
2. Press [Sub] [#]. Prompt reads:
Select submaster number
3. Press [Type]. Prompt reads:
Select submaster type
(1 = Pile-on, 2 = Inhibitive, 3 = Effect)
4. Press [1], [2] or [3] to select
type.
New type is entered in submaster
status bar
1.
See Bump button mode, page 161, for more information about the
LED.