User manual

16 Using Park 185
Parked Values in Live
Channels and parameters may be parked and unparked from the live display. To park from the live
display, you will use the {Park} softkey. Following are some examples:
To park a channel, parameter, or group from live:
• [2] [At] [5] [0] {Park} [Enter] - parks channel 2 intensity at 50%.
• [2] {Intensity} {Park} [Enter] - parks the intensity of channel 2 at its current value.
• [2] {Park} [Enter] - parks all parameters of channel 2 at their current settings.
• [2] [At] {Park} [Enter] - if channel 2 is unparked, this command parks intensity at the current
value. If the intensity for channel 2 is parked, this command unparks intensity.
• [2] {Color} {Park} [Enter] - parks channel 2 color at its current value.
• [Group] [Cue] [6] {Park} [Enter] - parks all the channels stored in cue 6 at their levels
provided in the cue.
• {Park} [Enter] [Enter] - clears all parked channels and scaled park instructions (see Scaled
Parked Values in Live, page 185). When a channel is unparked, it reverts to the level the
console is currently providing, or its default value if there is no current instruction.
Scaled Parked Values in Live
A scaled parked value allows the intensity output (only) to be modified proportionally in live. Scaled
park values are ignored when storing a record target. The setting on the display indicates what
should be stored, not the actual scaled value. An example of how to set a scaled parked value in
live includes:
• [3] [At] [/] [1] [2] [5] {Park} [Enter] - sets a scaled value of 125% on channel 3 intensity. In
other words, whenever channel 3 is active, it will be active 25% higher than its current setting.
• [3] [At] [/] [8] [5] {Park} [Enter] - sets a scaled value for channel 3. Whenever channel 3 is
active, it will playback 15% lower than its current setting.
Remove the scaled parked value:
• [3] [At] [/] {Park} [Enter] - unparks a scaled intensity for channel 3.
• {Park} [Enter] - unparks all parked channels.
A channel can have both a scaled parked value and a parked intensity value. Keep in mind that the
parked intensity has priority over (and overrides) scaled park values.
Parked Addresses in Live
DMX addresses can be parked in live.
Below are some examples of parking an address in live:
• [Dimmer/Address] [5] [At] [5] [0] {Park} [Enter] - parks output 5 at 50% intensity.
• [Dimmer/Address] [5] {Park} [Enter] - unparks output 5.
• [Dimmer/Address] {Park} [Enter] - unparks all parked outputs.
Note:
Parked values will only be displayed in the park display.
Note:
If a channel list is constructed in which some channels are parked and some are
unparked, {Park} [Enter] will unpark them all.