Operator`s manual

Operator's Manual
10
TF-DSQ-OM-E RevC
Assembling the TF-DSQ fixture
See the fixture overview to identify individual components.
System assembly is accomplished in the following steps:
1. Connect one end of the 50 Ω cable to the desired ProLink or ProBus extender (with
adapter).
2. Connect the other end of the 50 Ω cable to the SMA connector on the TF-DSQ fixture.
3. Connect the ProLink or ProBus CAT 5 cable from the extender to the TF-DSQ fixture.
Note: The 50 Ω connection should be torque tightened with an RF torque wrench and must be
properly tightened.