User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
- Apx H - Horizon 4.9 Specifications
- Apx I - Horizon 5.8 Specifications
CHAPTER8
ANTENNASETUPS
Revised: 25 Jan 17 8-9 ESTeem Horizon Series
8. Feed the CAT‐5e Ethernet connector(s) through the Face Plate Cover and secure the Ethernet Cable Boot to the cover.
ReferenceFig ure10.
NOTE: The Ethernet cable boot must be installed before the RJ‐45 end is installed.If using the ESTeem AA09.1 outdoor
Ethernetcable,verifythattheEthernetcab
lebootendisroutedtowardtheESTeemHorizon.
9. RoutetheCAT‐5eEthernetcable throughthemoldedstrain‐relieffinsintheFacePlateCover(Figure11)tosecure thecable
andprovidestrain‐relieffortheconnector.IfasecondEthernetcableisinstalled,removethesecondpo
rtcoverandroute
cable.
10. PlugtheCAT‐5eEthernetcabletotheHorizon’sEthernetportandsecuretheFacePlateCoverwiththeattachedthumbscrew.
VerifythattheweatherproofsealontheFacePlateCoverissealedagainsttheouterrim oftheHorizon.Refer enceFigure12.
11. Attachtheantennaconnectorboot
sasshowinFigure13foreitherdualattachedantennasorexterna lantennas.Youare
nowreadytomounttheESTeemHorizon
Figure11:FacePlateCoverStrainRelief
Figure10:EthernetCableRouting
Face Plate Cover
Ethernet Cable Boots
Second Port Cover
Remove for 2
nd
Cable