User's Manual

CHAPTER8
ANTENNASETUPS 
Revised: 25 Jan 17 8-4 ESTeem Horizon Series
Horizon5.8GHzAnt ennaandCableConfigurations

ESTeemoffersdifferenttypesofantennasforbothindoorandoutdoorconfigurations.Thisdevicehasbeendesignedtooper at e
withtheantennaslistedbelow,andhavingamaximumgainof22dBi.Antennasnotincludedinthislistorhavingagaingreater
than22dBiarestrictlyprohibitedforusewiththisdevic
e.Therequiredantennaimpedanceis50ohms.

Warning:ThisradiotransmitterESTeemHorizon5.8GHzcontainsFCCIDTV7R11E5HNDandonlythetestedcablelengthsand
antennasprovidedbyESTmeettheFCCmaximumpeakoutpu t powerrequirements.Anyothercombi n ationofantennasor
coaxcablesisnotauth
orized.Toreducepotentialradiointerferencetoot herusers,th eantennatypeanditsgainshouldbeso
chosenthattheequivalentisotropicallyradiatedpower(e.i.r.p.)isnotmorethanthatpermittedforsuccessfulcommunication.



PartNumber:AA20DMEa
 Omni‐directionaldirectmountantenna,4.5dBigain.
 Indoorandoutdoorapplications.
 Theremustbeaminimumseparationdistanceof23
cm.fromtheantennatotheuser.SeeWarnings.

PartNumber:AA20Ea
 Omni‐directionalex ternalpolemountantenna,10dBi
gainwith18‐inchintegralfeedlineandconnector.
 Outdoorapplications.
 Theremustbeaminimumseparationdistanceof23
cm.fromtheantennatotheuser.SeeWarnings.

PartNumber:AA205Ea
 Directionallinearpanel,polemountantenna,22dBi
gainwith18‐inchintegralfeedline,bandpass filterand
connector.
 Pointtopointandpointtomulti‐pointoutdoor
applications.
 Theremustbeaminimumseparationdistanceof50
cm.fromtheantennatotheuser.SeeWarnings.










Transmit/Receive
A
ntenna Port 1
Transmit/Receive
Antenna Port 2
Warnings:
Only pre-made coax cables from the factory used in
conjunction with either the omni-directional and
directional antennas meet all FCC Section 15.247(b)
EIRP maximum power requirements.
To comply with the FCC exposure compliance
requirements, a separation distance of at least 20 cm
must be maintained between the antenna and all
persons.