User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
- Apx H - Horizon 4.9 Specifications
- Apx I - Horizon 5.8 Specifications
CHAPTER8
ANTENNASETUPS
Revised: 25 Jan 17 8-2 ESTeem Horizon Series
Horizon900MHzAntennaandCableConfigurations
ESTeemoffersdifferenttypesofantennasforbothindoorandoutdoorconfigurations.Thisdevicehasbeendesignedtooper at e
withtheantennaslistedbelow,andhavingamaximumgainof7dB.Antennasnotincludedinthisli storhavingagaingreater
than7dBarestrictlyprohibitedforusewi
ththisdevice.Therequiredantennaimpedanceis50ohms.
This radio transmitter ESTeem Horizon 900 MHz (HVIN: 216AD) has been approved by Industry Canada to operate with the
antennatypeslistedbelowwiththemaximumpermissiblegainandrequiredantennaimpedanceforeachantennatypeindicated.
Antennatypesnotincludedinthisli
st,havingagaingreaterthanthemaximumgainindicatedforthattype,arestrictlyprohibited
forusewi ththisdevice.
LepresentemetteurradioESTeemHVIN:216ADaeteapprouveparIndustrieCanadapourfonctionneraveclestypesd'ante nne
enumeresci‐dessousetayantungainadmissiblemaximaletl'impedan
cerequisepourchaquetyped'antenne.Lestypesd'antenne
noninclusdanscetteliste,oudontlegainestsuperieuraugainmaximalindique,sontstrictementinterditspourl'exploitationde
l'emetteur.
Warning:Onlythetestedcabl elengthsandantennasprovidedbyESTmeet theFCCandDOCmaximumpeakou
tputpower
requirements.Anyothercombinationofantennasorcoaxcablesisnotauthorized.Toreducepotentialradiointerferenceto
otherusers,theantennatypeanditsgainshouldbesochosenthattheequivalentisotropicallyradiatedpower(e.i.r.p.)isnot
morethanthatpermittedforsuccessfulcommunication.
PartNumber:AA20DMs
Omni‐directionaldirectmountantenna,2dBigain.
Indoorandoutdoorapplications.
Theremustbeaminimumseparationdistanceof23
cm.fromtheantennatotheuser.SeeWarnings.
PartNumber:AA20Es900
Omni‐directionalex ternalpolemountantenna,7dBi
gainwith3‐ft.integralfeedlineandconnector.
Outdoorapplications.
Theremustbeaminimumseparationdistanceof
23cm.fromtheantennatotheuser.SeeWarnings.
PartNumber:AA203Es900
Directionalpolemountantenna,7dBigainwith3‐ft.
integralfeedlineandconnector.
Pointtopointandpointtomulti‐pointoutdoor
applications.
Theremustbeaminimumseparationdistanceof23
cm.fromtheantennatotheuser.SeeWarnings.
Notes:
Antenna Port A is a transmit and receive port for use in all
applications.
Antenna Port B is a receive only port and is used for dual
diversity antennas applications only. This port is not used
for point to point applications.
Warnings:
Only pre-made coax cables from the factory used in
conjunction with either the AA20Es900 omni-directional
and AA203Es900 directional antennas meet all FCC
Section 15.247(b) EIRP maximum power requirements.
Transmit/Receive
A
ntenna Port 1
Receive Only
Antenna Port 2