User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
- Apx H - Horizon 4.9 Specifications
- Apx I - Horizon 5.8 Specifications
CHAPTER7
BRIDGELINKSANDMESH
Revised: 09 Aug 2016 7-2 ESTeem Horizon Series
YoucanalsoconfiguretheMeshnetworkingdirectlythroughthewebconfigurationsetup(Chapter5).Figure3showsanexample
peer table from the setup menus.For the Horizon to communicate with another Horizon, select Yes must at Enable Peer
Capability.Next,theSerialNumberorWirelessLAN(WLAN)MACaddressofeachHorizonthatwillhavedirectcommunications
mustbeaddedtothePeerList.Finally,enablingthelinkallowsthecorrespondingHorizontobeincludedinthecommunication
routing.Mobileclientsdonotrequireinputintherepeaterpeertable.IfmultipleMeshroutesareconfigured,youwillalsoneed
to set the values for Priority and Path Leng
th (explained in Rapid Spanning Tree below). For multiple examples of repeater
configurations,pleaserefertoChapter3ofthisuser’smanual.
Figure3:Re pea t er ConfigurationExample