User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
- Apx H - Horizon 4.9 Specifications
- Apx I - Horizon 5.8 Specifications
CHAPTER3
EXAMPLEAPPLICATIONS
Revised: 27 Jun 16 3-15 ESTeem Horizon Series
MobileClientModeExample(Figure5)
EtherStation,StationRouterandStationMasqueradeModes
(3)ESTeemHorizon
SerialNumbers:
Z‐14000(EtherStation)
Z‐14001(StationRouter)
Z‐14002(StationMasquerade)
Setting the ESTeem for Mobile Client (station) mode with the ENC Utility is different than the
Bridge/RouterorAccessPoint(AP)modes.ESTeemmodemsconfiguredinasaMobileClientwill
not link with a specific fixed modem; bu
t will roam between any 802.11 Access Point with the
correctNetworkName(SSID)andEncryption.TheESTeemconfiguredasaclientisalsonotseton
a specific operating frequency (channel) but will scan all channels looking for the AP.Use the
followingproceduretoconfigureanESTee
mHorizoninoneofthethreemobileclientmodes:
1. StartinganewnetworkofESTeemHorizonsinMobile
Client mode is the same as any of the Bridge modes
exceptwhenyouareaskedforthefrequency(channel)
ofoperation,select“Station”(Figure23).
2. AddthethreemobileclientmodemstotheEN
CUtility
configuration page as instructed above and set the
Modem ID to match the three modes of operation.
YourconfigurationwillappearasinFigure24.
EtherStation
3. Bydefault,theENCUtilitysetsallstation modeESTeem
modems to EtherStationmode.The only adjustment
necessarytotheEtherStationmodeminourexampleis
to enter the connected Ethernet device’s MAC address.The
ESTeem Horizon will “clone” the Ethernet MAC address of the
connected Ethernet device.To configure the Et
herStation
modem,double‐clickontheicontobringuptheESTeemSummary
windowandpresstheEditbutton(Figure20).
4. EtherStationmodeshouldbeselectedintheModeofOperation.
PresstheNextbutton atthebottomofthewindowtocontinue.
EntertheconnectedEthernetdevice’sMA
Caddressinthe“Device
MAC Address” box (Figure 25) and press the Next button at the
bottom of the window to continue.
5. Verify the encryption settings are correct for the 802.11 AP
network in which the EtherStation modem will be working and
presstheFinishbuttontoreturntotheco
nfigurationpage.
TechnicalTip:TheESTeemHorizon’sinMobileClient
modesdonothaveaspecificfrequencyofoperation
ascanbeseeninFigure24.
Figure23:Station
Figure24:StationModeExampleModems
Figure25:MACAddressEntry