User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
- Apx H - Horizon 4.9 Specifications
- Apx I - Horizon 5.8 Specifications
CHAPTER3
EXAMPLEAPPLICATIONS
Revised: 27 Jun 16 3-12 ESTeem Horizon Series
Meshconfiguration(Figure17).FordetailedinstructiononMeshnetworkconfiguration,refertoChapter7ofthisUser’s
Manual.
4. Verify all ESTeem modems are
connected to the same switch as
the computer running the ENC
Utility and send the configuration
toallmodemsatthesametimeby
selecting ESTeem>ESTeem
Config
uration>Send Configuration
to All ESTeems. Once the ENC
Utility has downloaded the
configuration for both ESTeem
Horizon’s, the status box around
the ESTeem‘s will change from
yellow toblue.This indicatesthat
the configuration was completed
successfully and the ESTeem
Horizon’s are ready to be installed
intheapplication.
Figure16:BackupLinkConfiguration
Figure17:MeshNetworkConfiguration