User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
- Apx H - Horizon 4.9 Specifications
- Apx I - Horizon 5.8 Specifications
CHAPTER3
EXAMPLEAPPLICATIONS
Revised: 27 Jun 16 3-11 ESTeem Horizon Series
EthernetBridgeModeExample3(Figure3)
PointtoMultipointwithMeshRepeaterLinks
(6)ESTeemHorizon
SerialNumbers:
Z‐14000(MainOffice)
Z‐14001(RemoteOffice)
Z‐14002(Repeater)
Z‐14003(RemoteSite1)
Z‐14004(RemoteSite2)
Z‐14005(RemoteSite3)
1. Using the above procedure for adding ESTeem
Horizons, add the six ESTeem Horizons for this
example and rename by location.Your layout
shoulda
ppearlikeFigure16.
2. Move theESTeemHorizoniconson thescreento
simulate the layout of the diagram.Draw
connection lines between the primary wireless
linksmodemsinthesameorderasthenetworklayout(Figure17).
3. TocreatethebackuplinkbetweenRemote1an
dRemote2andtheotherbackuplinkfromRemote2totheRemoteOffice,
drawawirelessconnectionasyouwouldontheprimarylink.Double‐clickonthelinecreated.TheLinkEditorboxwillbe
displayed(Figure16).AnyPathLengthgreaterthan1willdisplayasada
shedlineindicatingabackuplinkintherepeater
Figure16:Example3Modems
Figure15:Example2Layout