User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
- Apx H - Horizon 4.9 Specifications
- Apx I - Horizon 5.8 Specifications
CHAPTER3
EXAMPLEAPPLICATIONS
Revised: 27 Jun 16 3-10 ESTeem Horizon Series
EthernetBridgeModeExample2(Figure2)
PointtoPointwithRepeaterEthernetBridge
(3)ESTeemHorizon
SerialNumbers:
Z‐14000(MainOffice)
Z‐14001(RemoteOffice)
Z‐14002(Repeater)
1.Using the above procedure, enter the three
ESTeem Horizons into the ENC Utility.Your
layoutshouldappearlikeFigure14.
2. MovetheESTeemHorizoniconsonthescreen
to simulate the layout of the dia
gram.Draw
connectionlinesbetweenthemodemstomake
the wireless link in the same order as the
networklayout(Figure15).
3. VerifyallESTeemmodemsareconnectedtothesameswitch
as the computer running the ENC Utility and send the
configuration to both modems at the same time by
selectingESTeem>ESTeemC
onfiguration>Send Configuration
to All ESTeems.Once the ENC Utility has downloaded the
configuration for both ESTeem Horizon’s, the status box
aroundtheESTeem‘swillchangefromyellowtoblue.Thisindicatesthattheconfigurationwascompletedsuccessfully
andtheESTeemHorizon’sarereadytobei
nstalledintheapplication.
TechnicalTip:Althoughitdoesnotmatterwherethe
ESTeem icons are located on the screen, putting
theminthesamelayoutastheapplicationmakesit
easiertovisuallyverifythenetworkconnections.
Figure14:Example2Modems
Figure15:Example2Layout