User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
- Apx H - Horizon 4.9 Specifications
- Apx I - Horizon 5.8 Specifications
CHAPTER3
EXAMPLEAPPLICATIONS
Revised: 27 Jun 16 3-9 ESTeem Horizon Series
EthernetBridgeModeExample1(Figure1)
PointtoPointEthernetBridge
(2)ESTeemHorizon
SerialNumbers:Z‐14000(MainOffice)andZ‐14001(RemoteOffice)
1. Add the two ESTeem Horizons to the network
using the aboveprocedure.Once both ESTeem
Horizonsareontheconfigurationpage,createa
wireless link by clinking on one of the two
connectionboxesanddr
aggingalinetotheother
modem(Figure13).
5. Verify both ESTeem modems are connected to
thesameswitchasthecomputerrunningtheENC
Utility and send the configuration to both
modems at the same time by selecting
ESTeem>ESTeemConfiguration>Send
ConfigurationtoAllESTeems(Figure14).
6. Once the EN
C Utility has downloaded the
configuration for both ESTeem Horizons, the
statusboxaroundtheESTeemswillchangefrom
yellow to blue.This indicates that the
configurationwascompletedsuccessfullyandthe
ESTeemHorizonsarereadytobeinstalledinthe
application.
Figure13:CreateWirelessLink
Figure14:SendConfigurationtoESTeem’s