User's Manual

 APPENDIXF
 HORIZON2.4SPECIFICATIONS



AntennaSpecifications


Revised: 25 Jan 17 APX F-5 ESTeem Horizon Series
ModelNo:AA204Eg.1
Applications:  Fixedbasemounting
AntennaType: 2.4GHzISM,Directional,DCGrounded,ParabolicGrid
Frequency:2400‐2485MHz
Polarization:VerticalorHorizontal
Impedance:50ohms
Gain:15dBi(13dBd)nominal
VSWR: <1.5:1nominal
FronttoBackRatio:  >24dB
HorizontalBeamwidth: 16degrees@½power
VerticalBeam
width:  11degrees@½power
AntennaMaterial: Zincplatedcoldrolledsteelwithpolyesterpower
coatfinish
RecommendedMounting
Hardware: StandardU‐boltsteelmastclampcompletewith
mountinghardware.Designedformastsofupto
2.5in.O.D.

AntennaConnector:  TNC‐RMalewith36in
.pig‐tail
MaximumPowerInput: 10Watts
WindSurvival:100mph
WindLoad:16mph
AntennaEnvelope:  34in.lengthby17in.widthby11in.height
Weight:3lbs.





UseoftheAA204Eg.1,directionalantennaislimitedtofixedpoint‐to‐pointapplicationsonly.InaccordancewithFCC
Section15.247(b)iii,thisantennamustbeprofessionallyinstalled.Theinstallermustensurethesystemisused
exclusivelyforfixed,point‐to‐pointapplicationsandtheESTeemModel195Egissetfor0.25Wattsou
tputpower(Power
Level=Min).



ModelAA204Eg.1
Caution
To comply with the FCC exposure
compliance requirements, a
separation distance of at least 50 cm
must be maintained between the
antenna and all persons.