User's Manual
Table Of Contents
- 210 User's Manual Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Repeating and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - FCC Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - 210C Specifications
APPENDIX E
TROUBLESHOOTING
Revised: 5 Dec 12 APX E-6 EST P/N AA107-210CM
EtherStation
How do I access the Model 210 web page in EtherStation Mode?
The Model 210 does not have an active web browser when
configured in EtherStation mode. You must access the ESTeem with the ESTeem Discovery Program or through the RS-232 port
after configuration in this mode. To monitor the link status, you can use the EtherStation Status program.
What IP address do I configure the ESTeem in EtherStation mode
? – The Model 210 will not have an IP address in EtherStation
mode.
I can not link my device into the wireless network
– Verify that the MAC address of the device is exactly the same as configured
in the Model 210. The MAC address must have colons between the values.
Can I connect my Model 210 in EtherStation mode to a HUB or Ethernet Switch?
– No. The modem must be connected directly
to the Ethernet device for which it is programmed. In EtherStation mode the Model 210 can only service ONE Ethernet device.