User's Manual
Table Of Contents
- 210 User's Manual Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Repeating and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - FCC Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - 210C Specifications
APPENDIX C
RADIO CONFIGURATION
Revised: 5 Dec 12 APX C-1 EST P/N AA107-210CM
210 FREQUENCIES OF OPERATION
In a wireless Ethernet network all of the ESTeem Model 210 must be set t
o the same radio frequency of operation. The frequency
of operation is selectable when configuring the mode of operation of the 210 (reference Chapter 3).
SETTING RF POWER LEVEL
The ESTeem Model 210 peak power is adjustable in output power from the advanced configuration menu. The output power is
adjusted on the Advanced
Menu>Wireless LAN Settings>Wlan0 Device screen (Figure 4) of the Web Configuration Manager.
Select the value and press the Save Settings button.
Max (Maximum) Full Power
Hi (High) 75% Power
Lo (Low) 50% Power
Min (Minimum) 25% Power
Figure 1: Advanced Global Variables
Figure 2: Power Level Settings