User's Manual
Table Of Contents
- 210 User's Manual Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Repeating and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - FCC Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - 210C Specifications
APPENDIX B
INTERFACE PORTS
Revised: 5 Dec 12 APX B-1 EST P/N AA107-210CM
ETHERNET INTERFACE
The ESTeem Model 210’s Ethernet Port is a Full and Half-Duplex Auto-negotiation interface supporting 10 Mbps, 100 Mbps and
1Gbps (10/
100/
1000BaseT). The port is compatible with TIA/EIA-568B cable configuration (Figure 1).
Figure 1: Ethernet Pin Layout
RS-232C DATA PORT CONFIGURATION
The ESTeem Model 210 has a 9-pin RS-232C data interface on the front panel. See Chapter 6 for further inform
ation on serial
data port configuration. To interface the 210 to the serial port on the computer, you need serial cable with the following pin-out:
ESTeem Model 210
RS-232C Port Pin-Out Table
Function
DB-9
Pin No.
Data Set Ready (DSR)
6
Data Carrier Detect (DCD)
1
Data Terminal Ready (DTR)
4
Signal Ground (GND)
5
Receive Data (RxD)
2
Transmit Data (TxD)
3
Clear to Sent (CTS)
8
Request to Sent (RTS)
7