User's Manual
Table Of Contents
- 210 User's Manual Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Repeating and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - FCC Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - 210C Specifications
CHAPTER 6
SERIAL APPLICATIONS
9.
10.
To set the IP address in the ESTeem 210, type the letter “A” and press the Enter key. Enter the value for the IP address,
Netmask and default route pressing the Enter key after each entry.
After the basic parame
ters have been entered into the Model 210 you will need to commit the changes to the Model 210
(Figure 3). Press the C key and then Enter. The changes will be saved to flash memory. You can use programming
features in the ESTeem Web Configuration Manager to configure the unit for your application.
Figure 2: RS-232 Welcome Screen
Figure 3: RS-232 Welcome Screen
Revised: 5 Dec 12 6-2 EST P/N AA107-210CM