User's Manual
Table Of Contents
- 210 User's Manual Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Repeating and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - FCC Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - 210C Specifications
CHAPTER 4
UTILITIES & FEATURES
Note: This program is saved in a compressed file format.
3. Doubl
e click on the 210DiscoverySetup<Current
Version>.exe file listed in the window to install the program.
Figure 4: Discovery Program Main Page
4. Connect the Model 210 to your computer either directly to the Ethernet card or through a HUB/Switch using a CAT-5e
Ethernet cable. The Ethernet port
on the 210 supports Auto-Negotiation, so either a patch cable or crossover cable will work.
Open the ESTeem Discovery Program and press the
Discover Modems
button. The Model 210 will be displayed in the
program by the Ethernet MAC address and Current IP Address (Figure 4).
Note: The SSID, Mode of Operation and Modem ID will be ad
justed through the ENC Utility or the Web Configuration
Manager...
5. Double-click on the 210 you want to program and the C
onfigure IP Address window will be displayed (Figure 5). Enter an IP
address and Subnet Mask for the 210 that matches your network subnet and press the
OK
button to save this to the ESTeem.
You will receive notification that the Configuration was Successful and the 210 will reboot.
Figure 5: Change IP Address Window
Revised: 5 Dec 12 4-3 EST P/N AA107-210CM