User's Manual

CHAPTER 1
INTRODUCTION
The Station Router mode will also functions as a mobile client, similar to EtherStation, but will allow multiple Ethernet
devices to be connected to a
single 210 (Figure 4). The 210 will function as a router between the wireless client mode
and the wired Ethernet devices connected to the Ethernet port. Similar in configuration to the Access Point Router mode,
the wireless and wired Ethernet networks will need to be on separate subnets. To communicate from wireless network to
devices on the wired Station Router network, a separate router (connected to the Ethernet side of the Access Point) is
required. This mode would be used where multiple Ethernet devices will be connected to a single Model 210 in a mobile
client application and the connected Ethernet devices will need to be accessible from the Access Point’s LAN network.
RS-232 Serial Applications
The ESTeem
210 i
s installed with an RS-232 data port for serial data applications run over the wireless links (Figure 6).
The serial network can be used in a point-to-point or point-to-multi-point application for networking serial (RS-232C)
devices, providing serial connections to legacy hardware in a new Ethernet network.
Figure 6: Multi-point Serial Diagram
To begin setup of your wireless Ethernet network, continue to Chapter 2 - Staring Out of this User’s Manual.
Revised: 5 Dec 12 1-4 EST P/N AA107-210CM