User's Manual
Table Of Contents
- Front Cover 195CM
- Table of Contents 195CM
- Chapter 1 - Introduction 195CM
- Chapter 2 - Starting Out 195CM
- Chapter 3 - Example Applications 195CM
- Chapter 4 - Repeating 195CM
- Chapter 5 - Ethernet Configuration and Applications 195CM
- Chapter 6 - Utilities and Features 195CM
- Chapter 7 - Antenna Setup 195CM
- Apx A - Software Commands 195CM
- Apx B - Interface Ports 195CM
- Apx C - Model 192 Integration 195CM
- Apx D - FCC Information
- Apx E - 195C Specifications
- Apx F - 195M Specifications
CHAPTER 2
STARTING OUT
Revised: 4 Feb 14 2-2 EST P/N AA107-195CM
Model 195C/M Hardware Configuration
The following steps should be completed to begin configuration of the ESTeem Model 195C/M:
1. Connect the antenna cable to the TNC connection on the ESTeem Model 195C/M (Figure 1).
Technical Tips:
1. Configure the Model
195C/M prior to mounting.
2. Attach antenna to the
Model 195C/M before
powering up.
2. Connect the power supply and Ethernet cable to the ESTeem
and proceed to Chapter 3 to
begin programming.
PC with Flash
Software Installed
10/100BaseT
Ethernet Cable
(Patch or Cross Over)
AA179 Power Supply
AA109
Resource
Disk
Test Antenna
(AA19C Shown)
TNC Female Antenna
Connection
Figure 1 – Basic Configuration Diagram