User's Manual
Table Of Contents
- Front Cover 195CM
- Table of Contents 195CM
- Chapter 1 - Introduction 195CM
- Chapter 2 - Starting Out 195CM
- Chapter 3 - Example Applications 195CM
- Chapter 4 - Repeating 195CM
- Chapter 5 - Ethernet Configuration and Applications 195CM
- Chapter 6 - Utilities and Features 195CM
- Chapter 7 - Antenna Setup 195CM
- Apx A - Software Commands 195CM
- Apx B - Interface Ports 195CM
- Apx C - Model 192 Integration 195CM
- Apx D - FCC Information
- Apx E - 195C Specifications
- Apx F - 195M Specifications
APPENDIX A
SOFTWARE COMMANDS
Revised: 4 Feb 14 APX A-7 EST P/N AA107-195CM
Number of milliseconds the ESTeem 195C/M will wait after receiving serial or Ethernet data packet before transmitting to remote.
Factory default = 1.
xhflow (0-1)
This command enables hardware flow control. Factory default = 0 (Disabled).
0 = Disabled.
1 = Enabled.
version
This command will display the current firmware version, boot loader version and firmware CRC.
vinaux
This command will display the DC voltage input in the auxiliary power is used.
zerotables
This software command will reset the Routes and Append commands to factory defaults (All blank).