User's Manual

APPENDIX A
SOFTWARE COMMANDS
Revised: 4 Feb 14 APX A-4 EST P/N AA107-195CM
netmask (*IP Address Netmask)
The netmask command sets the IP netmask for the ESTeem 195C/M. This command is used in conjunction with the ip_addr and
gw_addr commands to complete IP address for the ESTeem. Factory default = 255.255.0.0
network (0-255)
Network identification code. This is used to program a common code for all modems in the customers network so that another
facility on your frequency using the same addresses will not interfere with your equipment. Factory default = 37.
packdump (on/off)
This function enables monitoring of the data sent through the configured serial device interface (SDI). This troubleshooting tool
can be used to verify the operation of the wireless network by looking at both serial devices exchanging data. Factory default =
off.
on = Enabled.
off = Disabled.
packleng (1-2000)
This command defines the length of the data packet in bytes. Factory default = 2000.
packmon (on/off)
Places the ESTeem in the packet monitor mode. The packet monitor modem will allow the user to monitor all wireless packets by
their source, destination and repeaters. Please refer to ESTeem Packet Monitor Engineer Report for complete details on the
operation of this feature. Factory default = off.
parity (0-3)
This command defines the parity setting on the serial device interface. This command is used in conjunction with baud, databits,
and stopbits to set the complete serial configuration. Factory default = 1 (None).
0 = None Parity
1 = Even Parity
2 = Odd Parity
plcproto (0-7)
This command defines the PLC protocol emulation used on the selected serial device inteface. Factory default = 0 (None).
0 = None
1 = Rockwell Automation DF1
2 = Modbus RTU Protocol
3 = Modbus ENC_RTU Protocol (Configuration Protocol)
4 = ModbusTCP
5 = Opto22 Protocol
6 = Modbus ASCII
7 = Rockwell Automation EthernetIP