User's Manual

APPENDIX A
SOFTWARE COMMANDS
Revised: 4 Feb 14 APX A-3 EST P/N AA107-195CM
This command enables the Ethernet bridge on the ESTeem 195C/M. See Chapter 6 for full details. Factory default = off.
on: Enabled
off: Disabled
factory
The factory default command. The execution of this command causes the ESTeem to restore the command table values from
factory values that are stored permanently in memory. This will allow the user the ability to restore the ESTeem to factory
conditions during testing or set-up.
frequency (150.000-174.000) or (450.000-470.000)
This command programs the frequency of operation in the ESTeem 195C/M. The frequency is entered in MHz. Available
frequency ranges for each model listed below:
Public Safety Pool
Model 195M = 150.000-159.472574.000 MHz
163.250 MHz
166.250 MHz
169.000-172.000 MHz
172.225-173.39625 MHz
Business Pool
150.815-161.610 MHz
169.000-172.000 MHz
173.20375-173.36625MHz
Model 195C = 450.000-470.000 MHz
global (on/off)
This function will set the ability of the ESTeem to receive or not receive global messages (address = 255). Factory default = off.
on = Enabled.
off = Disabled.
gw_addr (*IP Address)
This command sets the Gateway address in the ESTeem 195C/M.
ident
This command sets the modem identification for the ESTeem 195C/M. This is a simple alpha-numeric value set in the modem for
easy identification in the network. This command can take up to 12 characters long and could be used for site name, location or
any value to easily identify. Factory default = <blank>.
ip_addr (*IP Address)
This command sets the IP address for the ESTeem 195C/M. Factory default = 172.16.8.1xx (where xx is the last two numbers of
the serial number).
model
Displays the product model of default firmware that is installed. Model should be the same as product being used.