User's Manual

TABLE OF CONTENTS
Revised: 4 Feb 14 Page 1 EST P/N AA107-195CM
CHAPTER 1 – Introduction
Before You Begin
1-1
Model 195C/M Overview
1-1
Serial Applications --------------------------------------------- 1-1
Ethernet Applications --------------------------------------------- 1-2
Sensor Applications --------------------------------------------- 1-2
Legacy Model 192 Applications --------------------------------------------- 1-2
CHAPTER 2 – Starting Out
Three Configuration Phases
2-1
Model 195Eg Hardware Configuration
2-2
CHAPTER 3 – Example Applications
Modes of Operation Description and Examples
3-1
Transparent Point to Point --------------------------------------------- 3-1
Transparent Multipoint --------------------------------------------- 3-3
PLC Emulations --------------------------------------------- 3-4
Programming Examples
3-5
Using Model 195C/M Configuration Utility --------------------------------------------- 3-5
Example 1 – Transparent Point to Point --------------------------------------------- 3-6
Example 2 – Transparent Point to Point with Repeater --------------------------------------------- 3-8
Example 3 – Transparent Multipoint --------------------------------------------- 3-9
Example 4 – PLC Emulation Mode --------------------------------------------- 3-10
Example 5 – Mobile Client Mode --------------------------------------------- 3-15
PLC Emulation Command Lists
3-11
CHAPTER 4 – Repeating Features
Configuring Route and Append Tables --------------------------------------------- 4-1
Reading Route and Append Tables --------------------------------------------- 4-3
Clearing Route and Append Tables --------------------------------------------- 4-3
CHAPTER 5 – Ethernet Applications
Programming Through Ethernet Port --------------------------------------------- 5-1
Ethernet Bridge Mode --------------------------------------------- 5-2
Using Ethernet as Serial Device Interface (SDI) --------------------------------------------- 5-3