User's Manual

ManualsBrandsElectronic Systems Technology ManualsElectronics217-220MHz VHF Telemetry Modem

Table Of Contents

CHAPTER 3

EXAMPLE APPLICATIONS

Point to Point Transparent Example 1 (Figure 1)

(2) ESTeem Model 195C

Transparent RS-232 Wireless Link

465.500 MHz at 2 Watts Output

Main Office Address – 172.16.10.182

Remote Site Address – 172.16.10.183

The 195 Series Narrow Band Configuration Tool

provides a graphical interface to the individual software

commands for the ESTeem 195C or 195M. On the

Configuration tab the software commands can be

displayed by their category. To display the status of all

software commands select the “All” commands radial and

press the Read Config button (Figure 7).

Figure 7: Model 195C/M Configuration Utility

Technical Tip: The unit address of the ESTeem

195C or 195M is the last octet of the IP address.

This single address is used when configuring the

destination and routing. Example – Main

Address IP = 172.16.10.182. Unit address = 182.

The fol

lowing are the software commands that need to be adjusted for point to point operation. For a complete list of software

commands and their definition, please refer to Appendix A (Software Commands) of this User’s Manual:

Main Office

Name Command Setting Notes

IP Address ip_addr 172.16.10.182 Set with Discovery Utility in setup above

Frequency frequency 465.500 Listed in MHz and set to operating frequency of network

RF Power rfpower 2 Watts Drop down menu 0.5 to 4 Watts - Output power on FCC license

Serial Data Interface sdi RS-232 Full

Handshake (port 3)

Drop down menu for configuring which port will transfer data

Baud Rate baud 19200 Configure serial port data rate

Setconnect Address setc 183 ESTeem address where data will be sent. Usually the unit address

of remote ESTeem.

Terminal Timer termt 10 Time gap in serial data before making RF packet and sending to

remote ESTeem (milliseconds)

Remote Site