User's Manual
Table Of Contents
- Front Cover 195CM
- Table of Contents 195CM
- Chapter 1 - Introduction 195CM
- Chapter 2 - Starting Out 195CM
- Chapter 3 - Example Applications 195CM
- Chapter 4 - Repeating 195CM
- Chapter 5 - Ethernet Configuration and Applications 195CM
- Chapter 6 - Utilities and Features 195CM
- Chapter 7 - Antenna Setup 195CM
- Apx A - Software Commands 195CM
- Apx B - Interface Ports 195CM
- Apx C - Model 192 Integration 195CM
- Apx D - FCC Information
- Apx E - 195C Specifications
- Apx F - 195M Specifications
CHAPTER 3
EXAMPLE APPLICATIONS
PLC Emulation Applications
The ESTeem 195C and 195M can support PLC based networks in both point to point and multipoint applications. The PLC
emulation driver allows the ESTeem to identify the destination address in the PLC message block and change the ESTeem
destination address to match. This PLC emulation allows the ESTeem 195C/M to support multiple repeaters in a network
(Figure 4). If repeaters are used with PLC emulation, the route and append table will also need configured (see Chapter 4 for
complete details).
PLC Protocols Supported
Rockwell Automation DF1 Full-Duplex
Rockwell Automation DF1 Half-Duplex
Rockwell Automation DF1 Radio Modem
Rockwell Automation Ethernet/IP
Modbus RTU
Modbus ASCII
ModbusTCP
Opto-22
Figure 4: Multipoint PLC Emulation Example
Revised: 10 Feb 14 3-4 EST P/N AA107-195CM