Quick Start Guide
Table Of Contents
- BEFORE YOU BEGIN
- MODEL 195Ep OVERVIEW
- The ESTeem Model 195Ep is a wireless LAN transceiver that can be used to build a Wireless Local Area Network (WLAN) for line-of-sight distances to 13 miles for fixed base and 5 miles for mobile applications at RF data rates up to 11 Mbps. The Model 195Ep is a very sophisticated networking device that can be configured for multiple modes of operation depending upon the needs of the wireless and wired LAN system. The following configuration modes are provided as an overview of the basic network types, as all possible network configurations can not be listed. or further help in selecting the correct network type, please contact Customer Support at 509-735-9092.
- MODEL 195Ep CONFIGURATION MODES
CHAPTER 1
INTRODUCTION
Revised: 15 Jun 06 1-4 EST P/N AA107P
195Ep in a mobile client application and the connected Ethernet devices will need to be accessible from the Access Point’s
LAN network.
8. Station Masquerade Mode. The Station Masquerade Mode is another mode where multiple devices will be connected to a
single ESTeem in a mobile or Client application, but unlike the Station Router mode, the Station Masquerate will consolidate
all connected Ethernet devices to a single IP address on the network. The devices connected to the Station Masquerade
195Ep will be able to access information from both the wireless and wired LAN, but will be inaccessible the other way similar
in application to a firewall. This mode would be used where multiple Ethernet devices will be connected to a single Model
195Ep in a mobile application and the IP addresses for each device will be hidden from the LAN connected to the Access
Point. See Figure 3.
To begin setup of your wireless Ethernet network you must first configure the Model 195Ep for the mode desired. Chapter 2 will
show several examples of the different modes of operation to help select the correct mode for your application.