Quick Start Guide
Table Of Contents
- CHAPTER 1 – INTRODUCTION
- Before You Begin
- Model 195Ep Overview
- Model 195Ep Access Point Configurations
- Figure 4: Access Point Masquerade Diagram
- Model 195Ep Access Point Repeater with Clients Configurations
- Model 195Ep Building to Building Configurations
- Model 195Ep Complete Wireless Solutions
- Overview
- Model 195Ep Hardware Layout
- ESTeem Discovery Utility
- Using The RS-232 Interface
- Logging Into Web Configuration Manager
- Web Configuration Manager
- CHAPTER 5 – EXAMPLE CONFIGURATIONS
- Programming Example
- Example 1 – Plant Network (Access Point Router Repeater)
- Example 2 –Repeater (Access Point Bridge Repeater)
- Example 3 – Remote Building (Access Point Bridge Repeater)
- Example 4 – EtherStation Mode
- Example 5 – Station Router Mode
- Example 6 – Station Masquerade Mode
- Overview
- ESTeem Mesh Network
- Spanning Tree Protocol (STP)
- Redundant Backup
- CHAPTER 7 – ANTENNA SETUPS
- Antenna and Cable Configurations
- Antenna Diversity
- Antenna Port Selection
- Coaxial Cable Attenuation
- Assembling the AA195PM Outdoor Pole Mounting Kit
- Model 195Ep Series with Direct Mount Dual Diversity Antennas
- Model 195Ep Direct Mount Antennas with Surge Protection
- Model 195Ep Series with External Mount Antenna
- Fresnel Zone
- APPENDIX A – FCC INFORMATION
- APPENDIX B – SPECIFICATIONS
- APPENDIX C – INTERFACE PORTS
- APPENDIX D – RADIO CONFIGURATION
- APPENDIX E – SECURITY
- APPENDIX F – TROUBLESHOOTING
- APPENDIX G – Quick Start Guide
- Before You Begin
TABLE OF CONTENTS
Revised: 15 Jun 06 Page 2 EST P/N AA107P
Using The RS-232 Interface
3-7
Installing ESTeem Utility Program --------------------------------------------- 3-7
Programming Using the RS-232 Port --------------------------------------------- 3-7
CHAPTER 4 – WEB CONFIGURATION
Logging Into Web Configuration Manager
4-1
Web Configuration Manager
4-2
Top Menu --------------------------------------------- 4-2
Setting ModemID Field --------------------------------------------- 4-2
Status Menu --------------------------------------------- 4-3
System Log Screen --------------------------------------------- 4-5
Setup Screen --------------------------------------------- 4-5
Advanced Configuration Screen --------------------------------------------- 4-6
Backup Screen --------------------------------------------- 4-6
Restore Screen --------------------------------------------- 4-7
Software Update --------------------------------------------- 4-8
System Reboot --------------------------------------------- 4-8
CHAPTER 5 – EXAMPLE CONFIGURATIONS
Programming Example
5-1
Programming Example #1 Diagram --------------------------------------------- 5-1
Programming Example #2 Diagram --------------------------------------------- 5-2
Table 1: Example System Configuration Table --------------------------------------------- 5-2
Example 1 – Plant Network (Access Point Router Repeater)
5-3
Example 2 –Repeater (Access Point Bridge Repeater)
5-13
Example 3 – Remote Building (Access Point Bridge Repeater)
5-18
Example 4 – EtherStation Mode
5-19
Example 5 – Station Router Mode
5-21
Example 6 – Station Masquerade Mode
5-25
CHAPTER 6 – REPEATING FEATURES
Overview
6-1
ESTeem Mesh Network
6-1
Configuration --------------------------------------------- 6-1
Spanning Tree Protocol (STP)
6-2
Overview --------------------------------------------- 6-2
Phases --------------------------------------------- 6-3
Priority and Path Cost --------------------------------------------- 6-4
Root Bridge --------------------------------------------- 6-4