User's Manual Part 2

CHAPTER 6
ANTENNA SETUPS
Revised: 12 Aug 04 6-1 EST P/N AA107G
ANTENNA AND CABLE CONFIGURATIONS
Warning: Only the tested cable lengths and antennas provided by EST meet the FCC maximum peak output power
requirements. Any other combination of antennas or coax cables is not authorized.
EST offers different types of antennas for both indoor and outdoor configurations.
Part Number: AA01S
• Omni-directional, rubber duck, direct mount, unity
gain antenna.
• Indoors and short range outdoor applications.
• There must be a minimum separation distance of 20
cm. from the antenna to the user. See Warnings.
Part Number: AA20DMg
• Omni-directional direct mount antenna, 3 dBd gain.
• Indoor and outdoor applications.
• There must be a minimum separation distance of 20
cm. from the antenna to the user. See Warnings.
Part Number: AA20Eg
• Omni-directional external pole mount antenna, 6 dBd
gain with 3-ft. integral feedline and connector.
• Outdoor applications.
• Antenna port B is not used in this configuration.
• There must be a minimum separation distance of 20
cm. from the antenna to the user. See Warnings.
Part Number: AA203Eg
• Directional pole mount antenna, 8 dBd gain with 3-ft.
integral feedline and connector.
• Point to point and point to multi-point outdoor
applications.
• Antenna port B is not used in this configuration.
• There must be a minimum separation distance of 20
cm. from the antenna to the user. See Warnings.
Part Number: AA204Eg
• Directional pole mount antenna, 17 dBd gain with 3-ft.
integral feedline and connector.
• Point to point applications only.
• Antenna port B is not used in this configuration.
• There must be a minimum separation distance of 50
cm. from the antenna to the user. See Warnings.
Antenna
Port A
Antenna
Port B
Notes:
Antenna Port A is
a transmit and receive port for use in
all applications.
Antenna Port B is
a receive only port and is used for
dual diversity antennas applications only. This port is
not used for point to point applications.
Warnings:
Only pre-made coax cables from the factory used in
conjunction with either the AA20Eg omni-directional
and AA203Eg or AA204Eg directional antennas meet
all FCC Section 15.247(b) EIRP maximum power
requirements.
Use of the AA204Eg, directional antenna is limited to
fixed point to point applications only. In accordance
FCC Section 15.247(b)iii, the operator or installer is
responsible for ensuring the systems is used exclusively
for fixed, point-to-point applications.