User's Manual

CHAPTER 3
STARTING OUT
Revised: 21 Mar 08 3-8 EST P/N AA107G
5. If your computer is configured properly, you will see the ESTeem Model 195Eg booting sequence on your Terminal Emulation
program. Once the ESTeem boot sequence is complete (approximately 30 seconds) you will receive this message:
“Please press Enter to active this console.”
If you don’t see this message press the Reset button on the front panel of the Model 195Eg and/or check the programming of
your RS-232 port.
6. Press the Enter key and you will be at the Configuration Menu 195Eg login prompt. See Figure 10.
7. To enter the Model 195Eg Main Menu you will need to log into the system with a login name and password.
8. If this is not the first time configuration of the Model 195Eg, see your network systems administrator for the password.
9. At the 195Eg login prompt type admin for the login name and press the Enter key (<Enter>). The login name is defined at the
factory and is not changeable by the user.
Note that all characters are lower case.
10. If this is the first time the Model 195Eg has been programmed or the Password was not changed from the factory default
values, the factory default password is also admin. Enter admin for the password and press the Enter key (<Enter>).
Note: All characters are lower case.
Figure 10: RS-232 Port Log-in Screen