User's Manual Part 2

CHAPTER 8
ANTENNA SETUPS
Revised: 11 Aug 08 8-1 EST P/N AA107D
ANTENNA AND CABLE CONFIGURATIONS
Warning: Only the tested cable lengths and antennas provided by EST meet the FCC and DOC maximum peak output power
requirements. Any other combination of antennas or coax cables is not authorized. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that permitted for successful communication.
EST offers different types of antennas for both indoor and outdoor configurations. This device has been designed to operate with
the antennas listed below, and having a maximum gain of 7 dB. Antennas not included in this list or having a gain greater than 7 dB
are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
Part Number: AA191Es
•
••
• Omni-directional, permanent vehicle mount antenna,
5dB gain with integral 17’ coax cable.
•
••
• Outdoor mobile applications.
•
••
• There must be a minimum separation distance of 23
cm. from the antenna to the user.
See Warnings.
Part Number: AA20DMs
•
••
• Omni-directional direct mount antenna, 2 dBi gain.
•
••
• Indoor and outdoor applications.
•
••
• There must be a minimum separation distance of 23
cm. from the antenna to the user.
See Warnings.
Part Number: AA20Es900
•
••
• Omni-directional external pole mount antenna, 7 dBi
gain with 3-ft. integral feedline and connector.
•
••
• Outdoor applications.
•
••
• There must be a minimum separation distance of 23
cm. from the antenna to the user.
See Warnings.
Part Number: AA203Es900
•
••
• Directional pole mount antenna, 7 dBi gain with 3-ft.
integral feedline and connector.
•
••
• Point to point and point to multi-point outdoor
applications.
•
••
• There must be a minimum separation distance of 23
cm. from the antenna to the user.
See Warnings.
Antenna
Port A
Notes:
Antenna Port A is a transmit and receive port for use in all
applications.
Antenna Port B is a receive only port and is used for dual
diversity antennas applications only. This port is not used
for point to point applications.
Warnings:
Only pre-made coax cables from the factory used in
conjunction with either the AA20Es900 omni-directional
and AA203Es900 directional antennas meet all FCC
Section 15.247(b) EIRP maximum power requirements.
Receive Only
Antenna Port