User's Manual Part 2

CHAPTER 5
EXAMPLE CONFIGURATIONS
Revised: 30 Jun 08 5-25 EST P/N AA107D
Example 6 – Mobile Vehicle #2 (Station Masquerade)
Review the Example Diagram #2 (Figure 2) and locate the 195Ed marked as Example 6. This ESTeem is connected to multiple
Ethernet devices in a mobile application and will be configured Station Masquerade mode. In this mode the 195Ed’s will gain
access to the wireless Ethernet canopy created by the Access Point and act as a firewall between the devices connected to the
Ethernet port and wireless network. Each of these networks will require a unique subnet to operate. In this configuration the
Ethernet devices connected to the Station Masquerade 195Ed can access the wired LAN network, but not the other way around.
This mode could be used if the Remote PC connected to the Station Masquerade needed to access the Internet (connected to the
wired LAN), but did not want to be seen by other Ethernet devices on the network.
1. Access the ESTeem Web page using your computer’s Web Browser as per instructions in Chapter 4. Select Setup from the
menu items. From the Select Mode of Operation pull down box , select Station Masquerade (Figure 44) and push the Next
button below the pull down box.
Figure 44:Station Masquerade Selection
Figure 45:DHCP, SSID and Encryption Settings