User's Manual
Table Of Contents
- 195Ea Chapter 0 - Front Cover 195Ea
- 195Ea Chapter 0 - Table of Contents
- 195Ea Chapter 1 - Introduction
- 195Ea Chapter 2 - Starting Out
- 195Ea Chapter 3 - Example Applications
- 195Ea Chapter 4 - Utilities and Features
- 195Ea Chapter 5 - Web Configuration Manager
- 195Ea Chapter 6 - Serial Configuration and Applications
- 195Ea Chapter 7 - Repeating and Mesh Networking
- 195Ea Chapter 8 - Antenna Setup
- 195Ea Apx A - FCC Information
- 195Ea Apx B - Specifications
- 195Ea Apx C - Interface Ports
- 195Ea Apx D - Radio Configuration
- 195Ea Apx E - Security
- 195Ea Apx F - Troubleshooting
CHAPTER 7
REPEATING FEATURES
Revised: 9 Sep 11 7-5 EST P/N AA107A
Redundant Backup
The ESTeem Model 195Ea configured in Access Point Repeater
mode will automatically function as a redundant backup if two
Model 195Ea’s are installed at the same location (Figure 7). If
two Model 195Ea’s are connected to the same switch, one of the
Model 195Ea’s will be Blocked when the Spanning Tree
Protocol is completed. The network will continue to use this
route until any problem with the original Model 195Ea is
detected and the second Model 195Ea will begin operation at
that site.
Redundant Master Configuration – The configuration in
Figure 7 will also provide a redundant backup for the Master
Site (Root Bridge). Configure both Model 195Ea’s as Root
Bridges (see above) giving the primary Root Bridge a value of 1
and the secondary Root Bridge a value of 2.
Figure 7: Redundant Backup Diagram