User Manual

CHAPTER 1
STARTING OUT
Revised: 2 Oct 01 1-4
Opening the ESTeem Configuration Menu
To enter the Model 192E Configuration Menu you will
need to log into the system with a login name and
password.
Note: These values can be changed from factory default
through the Configuration Menu. If this not the first time
configuration of the ESTeem, see you network systems
administrator for these values.
If this is the first time the ESTeem has been programmed
or the login was not changed from the factory default
values, please use the following to access the
Configuration Menu:
1. At the 192E login prompt type admin for the login
name and press the Enter key (<Enter>). Please note
that all characters are lower case.
2. At the Password prompt type admin for the password
and press the Enter key (<Enter>). Please note that
all characters are lower case.
The ESTeem Configuration Menu (Figure 6) will now be
displayed. Please proceed to Chapter 2 in this manual for
programming the ESTeem Model 192E for your specific
application.
Figure 5: Boot Prompt Example
Figure 6: Configuration Menu